Forum

First Grow / Closet Stealth Setup

Back To Top
Page 1 / 2 Next
kelleygreen420
Eminent Member
New Grower
First Grow / Closet Stealth Setup

Welcome to my first grow / grow journal. 

Thank each of you well in advance for any advice, encouragement, and shared knowledge! I am completely new to both horticulture and indoor gardening. 

Like some others here, the bulk of my understanding at this point is from reading everything I can get my hands on from Cocoforcannibis. 

I decided to go all in and have invested nearly $2k to get started. I am following the blueprint provided here to the letter.

I started by adding an APEC RO system as the EC of my well water was 280. It is now an EC of 2 or less. 

Setup: 

  • Mars Hydro 2x4 Tent
  • Mars Hydro SP250 Light 
  • Humidifier
  • Dehumidifier
  • Mini Oil Heater
  • 6” Fan
  • Auto Watering System per Docs specs 

Initial setup and dry run of tent made me realize I needed a heater. Humidifier is keeping up with one large vent open and 4” exhaust on low. Good negative pressure without too much imploding of tent.  

 

 

ReplyQuote
Posted : 01/22/2020 11:38 am Chefomj liked
+ Show 2 comments
Expand All Comments in this journal

Waiting on final deliveries of nutes, supplies and seeds..

ReplyQuote
Posted : 01/22/2020 11:41 am

Got my seeds! 

Let them sit out 24 hours to room temp. Scuffed with 400 grit (what I had laying around) and placed into 2 EC RO water warmed to 84°. Placed on heating pad on low and soaked for 3 hours. 

Germinating 4 seeds (2 White Widow & 2 Amnesia Molotov) with the plan to pot up placing the 2 strongest girls in final containers for grow. Any remaining plants I plan to hand off to a friend who plans to do a soil grow with. Better than simply discarding them in my mind. 

Placed in paper towels in sealed container and set on top of stereo receiver for warmth. Temp gun shows it at 90°. Thinking plastic container should insulate some and provide temps of mid 80’s for seeds. Will monitor to insure I do not cook them. 

ReplyQuote
Posted : 02/02/2020 11:47 am Chefomj liked

100% Germination of all 4 seeds. 

ReplyQuote
Posted : 02/03/2020 2:54 pm Chefomj liked
+ Show 1 comments
Expand All Comments in this journal

Placed sprouts in Jiffy pots at 39 hours. 3 of the 4 had tails in excess of 1/2”. The remaining White Widow had barely progressed beyond cracking. Marked that pot to monitor it’s progress. 

Turned down brightness on Mars SP250 and placed humidity dome under 24 hour lighting at 24” height in tent. Will monitor seedling growth to determine if adjustments need to be made to light intensity or height.

Tent environment is 80° and 60% RH. 

ReplyQuote
Posted : 02/04/2020 4:16 am Chefomj liked

Apparently I cooked my seedlings! 

I turned down the SP250, but not enough it seems. Ordered the LUX meter recommended and read through Dr. Photons article about light efficiency. 

Thinking to work with the LUX meter that will be useful throughout the grow and adjust my light rather than buy additional CFL’s and such. 

ReplyQuote
Posted : 02/07/2020 7:42 am

Pics

Cannabis Grow 392D98DD 6092 49EE B55D F55C19A2BC7E
Cannabis Grow 6868E492 C36F 4A26 8D8A 602A67F5453E

ReplyQuote
Posted : 02/07/2020 7:44 am Chefomj liked

I believe I had too many variables unaccounted for in not knowing light intensity in addition to not knowing temps inside humidity dome. 

I have ordered the LUX meter recommended here, along with a seedling Heat mat, temp probe, and Caliber IV hygrometer. 

I think now I stunted the seedlings with temps and lightning all over the place as I guesstimated intensity and distance and did not place Jiffy dome on a heating pad. I had the tent temps and RH correct at 75° and 75% RH however noted the Jiffy pots seemed quite cold to the touch. 

Does anyone know where soil temps should be in addition to environment? 

 

ReplyQuote
Posted : 02/07/2020 9:54 am Green Mountain liked
+ Show 2 comments
Expand All Comments in this journal

Got the LUX meter, seedling heat mat, and thermostat in from Amazon. 

After checking LUX settings of light, it does not appear light setting was terribly high although it was a bit high.

 

I am thinking now it was 2 things primarily. First, I was a little overzealous in making the hole for the roots in Jiffy. I used a Q-Tip thinking I would help the root by boring a hole out. Thinking now, it was too big and left the root with little contact to the media. 

Not using heat or keeping the media warm prior to transplanting sprout was likely the  main issue I had. 

 

I may have been able to save them however, with variables beyond me with no LUX meter or heat pad, I got frustrated and pitched them. 

ReplyQuote
Posted : 02/10/2020 8:03 am

Seeds are warming to room temp out of fridge for 48 hours. 

Will follow initial procedure of scuffing, soaking, and placing in Jiffy pots.

Warming Jiffy pots prior to transplant this time and place in tent on heat mat with thermostat set at 85°. 

Have Mars Hydro SP250 light dialed in at 5000 LUX at 24” Once seedlings open I will monitor for stretch and adjust height accordingly. 

Timing it so that I will be placing sprouts in tent, under 24/0 light at 5000 LUX, on heat mat set to 85°, under humidity dome for for the weekend undisturbed while away for Valentines weekend. Fingers crossed that all goes well and I return to happy little seedlings! 

Tent will be at 75° and RH% of about 60%. Running humidifier at lower setting should stretch range of tank capacity through the weekend. A bit redundant to micro climate of humidity dome, however seems prudent. 

Finally, thank you to those who responded both here and in the chat room. Such an awesome community! In spite of my disappointment, perhaps others may learn from my mistakes. 

ReplyQuote
Posted : 02/10/2020 8:19 am Green Mountain and Chefomj liked
+ Show 1 comments
Expand All Comments in this journal

Scuffed room temp seeds, soaked in PH Neutral RO water of 7.0 with an EC of 2. Placed in paper towels on heat mat set at 85° in sealed containers under a towel for darkness. 

Noted my RO water from the tap that was previously neutral PH was reading 8.0 today. Perhaps all the rain affected my well water. Glad I did not overlook checking this and will remember to not make any other “assumptions” moving forward.  

Sure hope this round is a success as this is the last of my seeds on hand. 

ReplyQuote
Posted : 02/11/2020 6:06 pm Chefomj and Green Mountain liked

Placed sprouts in Jiffy pots right at 39 hours again. 

This time I had the Jiffy humidity dome on the warmer set at 85° with a Calibre Hygrometer inside. Temp at 72° and RH reading High. 

One sprout took off with an incredibly long tail longer than the depth of the pot. I had to gently curl it around to get it placed in the pot. I marked the pot to see how it does. The remaining had tails about 1/2” also placed in pots. 

I was careful to fill soil back around the roots this time and placed the dome in the tent on the heat pad. I moved the thermostat probe inside the dome and set the heat mat to 75°. 

The light is dialed in to 5000 LUX at 24” recommended seedling height from Mars Hydro for the SP250. 

Now I wait.. more than a bit nervous given the outcome last attempt. 

ReplyQuote
Posted : 02/13/2020 8:56 am Chefomj liked

Returned from out of town to find the one seedling with the very long tail Had grown about 1 1/2” tall and cotyledons had not opened. Was able to gently open.

The remaining 3 pots showed no signs of life. So bummed!

Pulled the pots open and verified tails had not grown beyond growth in paper towels. I repaired pots and buried seeds a little deeper and gave them some fresh water in hopes of salvaging them. 

What is going on? Bad seeds? The one batch of Amnesia Molotov is from Kalashnikov Seeds and one remaining White Widow from Seedsman freebie. 

Hopefully the chat room will have some idea. Gonna order more seeds. This time with a breeder recommended. 

ReplyQuote
Posted : 02/17/2020 6:01 am

Could it be that I am using RO water without minerals re introduced for the sprouts? 

I watered them with my well water this morning. PH of 7.1 EC of 280 Temp 75°. 

ReplyQuote
Posted : 02/17/2020 6:54 am
+ Show 2 comments
Expand All Comments in this journal

Cannabis Grow 7CDE4FC3 CFB0 4A3D 9573 984E363BAECA

ReplyQuote
Posted : 02/17/2020 12:54 pm Chefomj liked
+ Show 1 comments
Expand All Comments in this journal
Back To Top
Page 1 / 2 Next